Differences between revisions 5 and 6
⇤ ← Revision 5 as of 2007-11-13 15:16:05 →
Size: 1954
Editor: Ordi-De-Marie
Comment:
← Revision 6 as of 2007-11-13 15:17:47 → ⇥
Size: 2052
Editor: Ordi-De-Marie
Comment:
Deletions are marked like this. Additions are marked like this.
Line 15: Line 15:
|| ?h.pial.mgz || make_outer_surface || ?h.outer-pial ||
|| ?h.outer-pial || mris_compute_lgi || ?h.lgi_pial ||
|| ?h.pial.mgz || make_outer_surface -se 15 || ?h.outer-pial || matlab||
|| ?h.outer-pial || mris_smooth -nw -n 3 || ?h.outer-smoothed || ||
|| ?h.outer-smoothed || mris_
compute_lgi || ?h.lgi.mgh || matlab ||

Local Gyrification Index (LGI)

Overview

Gyrification index is a metric that quantifies the amount of cortex buried within the sulcal folds as compared with the amount of cortex on the outer visible cortex. A cortex with extensive folding has a large gyrification index, whereas a cortex with limited folding has a small gyrification index. The method to be incorporated into Freesurfer is based on that of Marie Schaer, [http://ltswww.epfl.ch/~schaer/Schaer_TMI_accepted.pdf "A Surface-based Approach to Quantify Local Cortical Gyrification"], which computes local measurements of gyrification at thousands of points over the whole cortical surface.

Processing Stream

Stages

  1. From a freesurfer surface file (primarily ?h.pial, but ?.white or other surface files are possible), an 'outer surface' surface file is created, called ?h.outer-pial, which is basically a 'shrink-wrapped', or 'enveloped', version of the (pial) input. It is created either by a morphological closing operation which operates on a volume created using mris_fill (taking as input the pial surface file). Alternatively, a shrink-wrap utility (mris_shrinkwrap) could be used to create the outer-surface file.
  2. Once the outer-surface file is available, then the local gyrification measurements are calculated for each vertex of the outer-surface. To do this, circular regions of interest are defined for each vertex on the outer-surface, and the corresponding areas of each ROI are found on the pial surface. Finally, the local gyrification index (lGI) values are calculated at each pial vertices, and a scalar file is output (used in a similar manner as a 'thickness' scalar file).

I/O

Input

Process

Output

Notes

?h.pial

mris_fill -c -r 1

?h.pial.mgz

?h.pial.mgz

make_outer_surface -se 15

?h.outer-pial

matlab

?h.outer-pial

mris_smooth -nw -n 3

?h.outer-smoothed

?h.outer-smoothed

mris_compute_lgi

?h.lgi.mgh

matlab

LGI (last edited 2015-09-18 17:22:55 by LeeTirrell)